Скачать с ютуб How to fix blobs while printing using Octoprint - 3d printer -Marlin updates and Cura settings в хорошем качестве

How to fix blobs while printing using Octoprint - 3d printer -Marlin updates and Cura settings

This video goes over the changes I made to fix the blobs on curved surfaces on my cr10s. I go over the Marlin settings I changed as well as the Cura updates to fix this issue. This should work on other printers including the cr10, ender3, cr10s, and other popular fdm printers. This plugin came out after the video, and it would also appear to improve the curves, I havent tested it yet but its worth looking into: https://plugins.octoprint.org/plugins... #blobs #zits #3dprint Other videos I have created for 3d printing and octorpint- How to install firmware updates using Octoprint:    • Update CR-10S firmware using Octoprin...   How to configure Th3d Firmware (marlin):    • Marlin Firmware Tutorial 3d printer (...   From Simplify3d: "You’ve waited hours for your 3D print to finish. Finally, the extruder stops, the print bed lowers, and the moment of truth has arrived. At first glance, the print looks perfect. But wait, what the heck? Are those blobs on the surface of the part? We’ve all felt that sinking feeling that comes with seeing blobs marring our 3D prints. Small surface imperfections, also called “zits,” are especially annoying when they appear on an otherwise perfect print. These blobs can occur because the extruder frequently starts and stops as it moves around during a print. The blobs represent the location where the extruder started printing a section of the outer shell of your model, then eventually returned to the same spot once it was done printing that perimeter. Joining two sections of plastic without leaving any sort of mark is not easy, but there are ways to help prevent those pesky blobs from appearing on the surface of your print. We cover them in detail in the Print Quality Troubleshooting Guide, but here’s a quick look at what might be causing surface defects. Too much plastic Before you can attempt to reduce blobs, it’s important to know where they are occurring. Watch your print in progress. Do blobs happen as the perimeter starts printing, or at the end of that layer as the extruder comes to a halt? If the blobs happen right at the beginning of the perimeter, it is possible the extruder is priming too much plastic. To counteract this, try adjusting your retraction settings to add a negative extra restart distance. For instance, if your retraction distance is 2.0mm, and you add an extra restart distance of -0.4mm, every time the extruder stops, it will retract 2.0mm of filament. But when it starts again, it will only push 1.6mm of filament back into the nozzle. Tweak this number until the blobs stop appearing. Detailed instructions on how to do this can be found in the Print Quality Troubleshooting Guide. Built-up pressure inside the extruder Blobs can occur when the built-up pressure inside the extruder nozzle pushes out more plastic than intended. If you notice that the blob is happening as the extruder finishes printing a perimeter, you may want to adjust a setting called “coasting.” This setting relieves some of the built-up pressure within the extruder by turning it off just before the end of the perimeter. Try turning this feature on and increasing the value until the blob no longer appears. Here are comprehensive instructions on how to adjust coasting." https://www.simplify3d.com/preventing...