Скачать с ютуб HOW TO MAKE A WATER PUMP From MOTOR AT HOME AWESOME IDEAS в хорошем качестве

HOW TO MAKE A WATER PUMP From MOTOR AT HOME AWESOME IDEAS

How to make powerful water pump at home 775 motor ( transparent centrifugal pump) For this we need: 1. Plastic jars with lids - 2 pcs. 2. Syringes - 2 pes. 3. Engine 12 volts 4. Super Glue + hot melt 5. Wires, how to, diy, home made, howto, how to make a water pump, turbine, water, water turbine, motor, battery, switch, pump, how to make mini water pump, how to make water pump at home, water pump project, water pump kaise banaye, homemade water pump, how to make electric water pump, mini water pump, diy water pump, awesome ideas, homemade pump, school project, how to make powerfull water pump, high speed water pump, creative ideas Manufacturing 1. Cut out the cover in the center of the circle and make a hole equal to the diameter of the motor shaft. In my case, 3 mm. 2. Cut blade impeller. I made the blade is too wide, it is better to make them smaller (5-7 mm). Stick to the disk. PS Ring on the blades serve to increase the stiffness, but it was odd. 3. Cut off the bottom of the cans (It will be part of the pump casing. The size depends on the height of the impeller. There must be a reserve of a few millimeters) and make 2 holes. One side angle equal to the inner diameter of the syringe (By the rotational direction of the blades). In my case, 10 mm (12 mm syringe) A second hole for the protruding portion of the engine 4. Cut off the syringe at an angle and then slightly rounded scalpel for a snug fit to the curve of the banks. Stick to the hot melt adhesive. Then superglue to glue engine. 5. In the cover to make a hale for water intake 10 mm and glue gun. 6. On the side to make a cutout for the syringe. 7. drop of superglue to the center of the impeller and fit onto the motor shaft Drip a little glue for a better setting 8. On the inside of the lid cause hot melt and stick to the bottom of the jars. 9. Solder the wires to the engine and tie them in a knot 10. At the bottom of the can do a small hole under the wire and push wire in it. 11. Glue the motor housing to the pump casing, using hot melt glue. Shev carefully fuff melting for a better seal. 12. Seal the hole exit wire hot glue. 13. The pump is ready. It is safe to lower it into the water and experience the performance. If you do not dangle, then change the polarity #jeffreestar #centrifigualpump #powerfullpump how to make a water pump, DIY water pump, homemade water pump, how to make a water pump at home, mini water pump, how to make a water pump work, noise of water pump, how to, DIY